In the season where the rain is relatively frequent, in addition to the work UV that needs to do a good job of sterilization and dehumidification, it is also necessary to focus on the rust-proof treatment of the vehicle chassis. If it is found that the brake pump on the site of the garbage sweeper has a break in the branch pump line and a brake fluid is leaking, it can actually be made of copper or iron sheet under the branch of the branch pump. The small mat, which blocks the leaking brake fluid, can achieve a leak-stopping effect by using a tightening screw and flattening and crimping the port. However, this way of doing will cause this round to no longer achieve the braking effect, but also caused a situation of unilateral braking, so be very careful when driving a garbage sweeper. If there is a breakage in the tie rod ball joint of the garbage sweeper, if it can be ensured that the other position of the bumper will not cause the vehicle to go unsuccessfully, another screw with a length similar to the length of the ball joint can be used. Instead of breaking the ball section. After the installation curtain has its own knuckle arm assembly, it is sufficient to rivet the exposed part of the bolt. If it is a three-axle trash sweeper, if the gear oil of the differential is found to be damaged, either the rear axle or the differential on the middle bridge will be broken, it will be able to break the broken half-shaft and The drive shaft was disassembled and it was then able to continue driving. If the front differential is broken, you can disassemble the hub of the garbage sweeper and continue driving. Wait until you reach the repair station for professional repairs. If the brake master cylinder of the garbage sweeper has brake fluid missing, it can be temporarily replaced with liquor and alcohol. If there is a case of a brake cup rising, place the soaked cup in a hot water bath for between ten minutes and twenty minutes, and then deal with the place where the oil on the garbage sweeper bowl contains oil. , then it will make the cup can be restored to its original size.
Brass forging is the same as other metal forgings, the main feature is that it can change the internal structure of the metal and improve the mechanical properties of brass. The original state of forged brass materials includes brass bar, brass ingot, brass powder and liquid brass, etc. The bar has uniform grain structure and mechanical properties, accurate shape and size, and good surface quality, suitable for demanding and mass production. Because brass has the characteristics of wear resistance, good electrical conductivity and good corrosion resistance, copper forgings are often used in marine projects, automotive machinery, communications, plumbing and other industries.
For copper forging, the main reason is that the forging temperature is relatively narrow. Usually, induction heating can be used for hot forging. However, a reasonable solution can be selected according to specific products and specific requirements. SCZY has been working in copper forging for a long time and has corresponding experience, so it can reasonably predict the processing of products.
Brass Forging Parts,Brass Forging Automobile Parts,Copper Forging Construction Machinery Parts,Brass Forging Parts For Industrial Equipment,Brass forging,Brass forgings Shenzhen SCZY Technology Co.,Ltd , https://www.szsczycasting.com
