When turning a tanker car to a corner, the tanker must accurately determine the corners and curvature of the curve so as to be able to use the driving speed and the driving position in an appropriate manner so as to safely navigate the curve. . Turning road sections are the locations where traffic accidents occur frequently. What should you watch out for when tankers drive into corners? When the tanker is driving to some sections where there are many corners and narrow roads, the most important thing is to control the speed and change the gears in time. Before the vehicle is driving to the curve, it should be in accordance with the condition of the lower curve, at the same time lift the accelerator pedal and foot brake to brake, and then need to be selected in a more appropriate gear and speed (normal conditions All are used to resist, and need to be selected in a more appropriate driving route and location. When the vehicle makes a turn, it generates a relatively large centrifugal force, and can shift the vehicle from the direction of the outer ring. In this case, the smoothness of the tanker driving is directly affected, and even more serious accidents may occur when the vehicle rolls over. Therefore, the correct operation is based on the radius of curvature of the curve and the speed of the vehicle. When the vehicle enters the curve, the accelerator pedal should be relaxed to allow the tanker to run more smoothly. The tanker cannot slow down and accelerate when driving to a bend. This can cause traffic accidents. Because it is absolutely possible for a vehicle with a precursor to cause understeering when crossing corners more quickly, and it is easier for rear-wheel drive vehicles to cause oversteer. This will change the rules of the vehicle. At the same time, the emergency braking in the corners is likely to lock the car in a deadlock. In this case, the control of the steering and the status of turning and tail flicking will be lost. Before the tanker has entered the corner, he should first depress the brake pedal to slowly decelerate the vehicle. If the curve into the tanker is relatively large, then it should be further decelerated, if necessary. You can lower the gear. After entering the corner at a low speed, the line for turning can be selected and the direction can be corrected, and the corner can be turned out at an accelerated speed. Then, for those models that use manual transmission, when the vehicle enters a corner, it is necessary to avoid the operation of shifting, because when the driver controls the steering wheel while one hand is shifting, It is also likely to cause the accident. Gravitational Gold Concentrator
It is suitable for the recovery of single gold in placer gold, vein gold mines and polymetallic mines, instead of mercury plate operations. The addition of large single gold particles in the collected ore before flotation can further increase the recovery rate of gold mines, and it can also be used from gold-bearing mines. Separate single gold from flotation gold-copper concentrate and flotation gold concentrate.The device has the following characteristics:
1.Wide application field: the device can regenate various types of activated carbonon by adjusting the angle and rotational speed of furnace pipe.
2.Regeneration activated carbon in the oven retention time 40 minutes, which is applicable to the regeneration levelofall kinds of grain particles, for coal activated carbon also has good regeneration effect.
3.High degree of automation:the device operation achieves automatic control,with man-machine interface+Intelligent instrument control,reduces the operating workers and the labor intensity is low.
4.High recovery rate of Iodine value:basically returned to a new carbon levels above 90%.
5.Low carbon loss:≤1-2%(Coal carbon)But slightly higher than the JHR-O series activated carbon fuel diesel reclamation equipment
6.Easy installation, covers an area slightly larger, but the small space height requirements, large installed power.
Long service life:The core components furnace tube using thick wall (10 mm thick) 1200 ℃ high temperature resistance, corrosion resistant special stainless steel pipe.
Gravitational Gold Concentrator,Gold Extraction,Gold Recovery Equipment,Gold Washing Equipment Changchun Gold Research Institute Co.LTD , https://www.changchungoldresearch.com
