According to the website of the General Administration of Quality Supervision, Inspection and Quarantine, Sichuan Automobile Industry Co., Ltd. filed a recall plan with the AQSIQ according to the requirements of the Regulations on the Management of Defective Automobile Product Recall, and decided to recall 2011 from December 10, 2014. A total of 7966 F99MT, F10MT and F12MT light buses were produced from November 1st to October 31st, 2012. It is understood that some vehicles in this recall range have low protection capability due to ABS actuator assembly. Under extreme conditions, they may be affected by transient surge pulses of the entire vehicle circuit, causing damage to individual ABS internal components and forming a current loop. This causes the heat to accumulate continuously, causing the ABS board to ablate, posing a safety hazard. Sichuan Automobile Industry Co., Ltd. will inspect the vehicles within the scope of the recall and replace the qualified ABS actuator assemblies with free vehicles to eliminate safety hazards. The AQSIQ will organize the supervision of this recall. If vehicles outside the scope of the recall are found to have similar safety hazards, or the recall measures cannot effectively eliminate the defects, the producers will be required to recall them again or take other enforcement measures. The General Administration of Quality Supervision, Inspection and Quarantine said that Sichuan Automobile Industry Co., Ltd. will contact the relevant owners through the Mustang Auto Authorized Service Station to arrange free maintenance. Users can call the customer service hotline 400-628-5999, 800-829-8008 or the local Mustang Auto Authorized Service Station hotline for consultation. Owners can also visit the AQSIQ website () and the AQSIQ Defective Product Management Center website () for more information. In addition, you can also call the AQSIQ Defective Product Management Center hotline to reflect problems during the implementation of the recall or submit defects. No-Magnetic Stainless Steel Shot Longlived Metal Products CO.,LTD chooses high-quality No-Magnetic Stainless Steel, which has relatively high non-magnetic properties, so it has three major advantages: No-Magnetic Stainless Steel Shot,No Magnetic Stainless Steel Shot,No Magnetic Stainless Steel Beads,No Magnetic Steel Shots Longlived Metal Products Co ., Ltd , https://www.longlivedmetalproducts.com
1. The steel shot produced does not need to be demagnetized, and it is non-magnetic or weakly magnetic;
2. The non-magnetic steel shot has bright color, clear surface, uniform particles and no impurities;
3. The performance of non-magnetic steel shot is close to that of 304 Stainless Steel Shot, and there is no various oxidation and impurities after demagnetization of 304 steel shot, so it has a very high cost performance;
4. It is not easy to generate working magnetism in the process of throwing and beating, so the steel shot can be efficient and practical, avoiding repeated cleaning and repeated addition of steel shot, which not only saves costs but also improves work efficiency.