Chemical Pipette Filler Uses in Laboratory

Chemical Pipette Filler Uses in Laboratory

Model: MCL-Levo Plus

•   Compatible with most ofthe plastic and glass pipettes from 0.1 -100mL
•   Eight speeds of selection for aspiration and dispensing different liquids
•   Large LCD display showing low battery warning and speed settings
•   Enables single-handed operation with minimum effort
•   Light and ergonomic design providing easy usability
•   High capacity Li-ion battery enable long runtime of operation
•   Powerful pump fills a 25mL pipette in<5 seconds
•   0.45μm replaceable hydrophobic filter
•   Rechargeable during use
 

Chemical Pipette Filler Uses in Laboratory

Model: MCL-Levo Plus

•   Compatible with most ofthe plastic and glass pipettes from 0.1 -100mL
•   Eight speeds of selection for aspiration and dispensing different liquids
•   Large LCD display showing low battery warning and speed settings
•   Enables single-handed operation with minimum effort
•   Light and ergonomic design providing easy usability
•   High capacity Li-ion battery enable long runtime of operation
•   Powerful pump fills a 25mL pipette in<5 seconds
•   0.45μm replaceable hydrophobic filter
•   Rechargeable during use
 

Tube Type Heat Exchanger

fixed tube heat exchanger
The structure of fixed tubesheet heat exchanger is simple, compact and cheap, but cannot be cleaned mechanically. This tube bundle of heat exchanger is connected ontubeplate, which is welded on both ends of the shell, the top cover connected are equipped with fluid inlet and outlet nozzles.A series of baffles perpendicular to the tube bundle are usually installed outside.Two different temperatures fluids inside out, therefor regid material is used. Therefore, to avoid thermal expansion between tubes inside out when temperature difference is higher than 50°C, automatic temperature compensator needs to be installed.However, the compensation device can only be used in the case that the pressure of the shell side fluid is not high when the temperature difference between the shell wall and the pipe wall is less than 60-70°C. Generally, when shell side pressure exceeds 0.6Mpa, because compensation ring is too thick, it is difficult to expand and lose the role of temperature compensation, other structures should be considered.

High Efficiency Tube Heat Exchanger,Tube Heat Exchanger For Electroplating,Stainless Steel Tube Heat Exchanger,Industrial Tube Heat Exchanger

Yangzhou Tongyang Chemical Equipment Co., Ltd. , https://www.tongyangchemic.com