1. crushing teeth plate jitter, can hear the crash metals. Cause: The crushing chamber liner or broken tooth plate is loose, and the fixing bolt is loose or broken. Remedy: Stop the inspection, hit the fixed wedge iron on the side wall with a hammer, then tighten the fixing bolts or replace the damaged bolts. 2. The impact sound is generated in the thrust plate support pad. Cause: The spring tension is insufficient or damaged, and the thrust plate support pad is worn. Removal method: adjust the spring tension or replace the spring, and replace the support pad or thrust plate. 3. The impact of the head of the connecting rod. Cause: The eccentric shaft bushing is worn. Elimination: Re-scrape or replace the bushing. 4. Broken product size increase Cause: The lower part of the broken tooth plate is seriously worn. Elimination method: adjust the discharge port, reduce the size of the discharge port, or replace the broken tooth plate by 180 ° or replace the new tooth plate. 5. After the iron is over, the support will stop swinging, the connecting rod will swing back and forth, and the pull rod spring will be relaxed. Cause: The thrust plate is broken or the rivet is cut when the iron is over. Elimination: Replace the new force board. Strengthen the work of removing iron, and it is strictly forbidden to fall into the crushing chamber. 6. The thrust plate falls off the support pad Cause: The lever or lever spring is damaged and the lever nut is tripped. Elimination: Replace the damaged parts and reinstall the thrust plate. 7. The flywheel swings significantly and the eccentric shaft rotates slowly. Cause: The coupling of the pulley and the eccentric shaft is loose or damaged. Elimination method: Replace the joint key. 8. The rolling bearing heats up. Causes and elimination methods: If the oil quantity is insufficient, it should be added; if the oil quality is not good, oil needs to be changed; if the assembly is too tight, it should be adjusted; if the belt is too tight, it should be loosened. 9. The host will not turn after the power is turned on. Cause: The motor burned or was broken, and the belt was too loose. Elimination: Repair the motor or tighten the belt. Cat Litter,Water Absorbency Clay Cat Litter,Strong Water Absorbency Cat Litter,Water Absorbency Cat Litter XUYI BOTU ATTAPULGITE CLAY CO.,LTD , https://www.xuyibotu.com